trezor-firmware/core/embed/firmware/systemview.c

#ifdef SYSTEM_VIEW

#include <stdint.h>

#include "SEGGER_SYSVIEW_Conf.h"
#include "SEGGER_SYSVIEW.h"

#define SYSTICK ((SYSTICK_REGS*)0xE000E010)
#define SCS     ((SCS_REGS*)0xE000ED00)

typedef struct {
    volatile unsigned int CSR;
    volatile unsigned int RVR;
    volatile unsigned int CVR;
    volatile unsigned int CALIB;
} SYSTICK_REGS;

typedef struct {
    volatile unsigned int CPUID;       // CPUID Base Register
    volatile unsigned int ICSR;        // Interrupt Control and State Register
    volatile unsigned int VTOR;        // Vector Table Offset Register
    volatile unsigned int AIRCR;       // Application Interrupt and Reset Control Register
    volatile unsigned int SCR;         // System Control Register
    volatile unsigned int CCR;         // Configuration and Control Register
    volatile unsigned int SHPR1;       // System Handler Priority Register 1
    volatile unsigned int SHPR2;       // System Handler Priority Register 2
    volatile unsigned int SHPR3;       // System Handler Priority Register 3
    volatile unsigned int SHCSR;       // System Handler Control and State Register
    volatile unsigned int CFSR;        // Configurable Fault Status Register
    volatile unsigned int HFSR;        // HardFault Status Register
    volatile unsigned int DFSR;        // Debug Fault Status Register
    volatile unsigned int MMFAR;       // MemManage Fault Address Register
    volatile unsigned int BFAR;        // BusFault Address Register
    volatile unsigned int AFSR;        // Auxiliary Fault Status Register
    volatile unsigned int aDummy0[4];  // 0x40-0x4C Reserved
    volatile unsigned int aDummy1[4];  // 0x50-0x5C Reserved
    volatile unsigned int aDummy2[4];  // 0x60-0x6C Reserved
    volatile unsigned int aDummy3[4];  // 0x70-0x7C Reserved
    volatile unsigned int aDummy4[2];  // 0x80-0x87 - - - Reserved.
    volatile unsigned int CPACR;       // Coprocessor Access Control Register
} SCS_REGS;

extern uint32_t SystemCoreClock;

U32 SEGGER_SYSVIEW_X_GetTimestamp ()
{
//    static U32 i = 0;
//    return i++;
    return (*(U32 *)(0xE0001004));
}

U32 SEGGER_SYSVIEW_X_GetInterruptId()
{
//    static U32 i = 0;
//    return (i++) % 200;
    return ((*(U32*)(0xE000ED04)) & 0x1FF);
}

void enable_systemview() {
    SEGGER_SYSVIEW_Conf();
    SEGGER_SYSVIEW_Start();

    U32 v;
    //
    // Configure SysTick and debug monitor interrupt priorities
    // Low value means high priority
    // A maximum of 8 priority bits and a minimum of 3 bits is implemented per interrupt.
    // How many bits are implemented depends on the actual CPU being used
    // If less than 8 bits are supported, the lower bits of the priority byte are RAZ.
    // In order to make sure that priority of monitor and SysTick always differ, please make sure that the difference is visible in the highest 3 bits
    v = SCS->SHPR3;
    v |= (0xFFuL << 24);   // Lowest prio for SysTick so SystemView does not get interrupted by Systick
    SCS->SHPR3 = v;
    //
    // Configure SysTick interrupt
    // SysTick is running at CPU speed
    // Configure SysTick to fire every ms
    //
    SYSTICK->RVR = (SystemCoreClock / 1000) - 1;     // set reload
    SYSTICK->CVR = 0x00;      // set counter
    SYSTICK->CSR = 0x07;      // enable systick

}

#endif